Step 1

Remove the protective film from both sides of the cover. The film is there to protect your shield during shipping. Your cover should be perfectly clear after film removal.

Step 2

If your Euro plate is already installed in the mounting frame, remove it. We recommend you clean the plate with water only prior to installing the cover. Place the clear cover/shield on top of your Euro plate and align the edges with edges of your license plate.

Step 3

Slide the plate and cover under the tab on the left side of the mounting frame. Repeat with the tab on the right side of the plate.

Step 4

Continue to push the plate and cover towards the top of the frame. Be sure to push with both hands evenly on both sides of the plate/cover. Both the plate and cover should slide under all 4 tabs on top of the frame. You may need to pull lightly up on the tabs to get underneath them. Push until both the plate and cover are snug against the top of the frame.

Step 5

Push down on the bottom of the plate/cover until the bottom edge of the license plate snaps into the small tab in the frame.

Step 6

Install the black bottom strip of the mount frame by sliding the strip from side towards the edge of the frame. Repeat on the opposite side.

Step 7

Push down on the center of the black strip until it snaps in place.

And that's it! You can clean the shield with water or a non-amonia based glass cleaner and a microfiber towel. If the cover becomes overly scratched or caked in bugs just replace with fresh one!